Clock Initialization

[ Team LiB ]

Clock Initialization The receive FIFO in each device must be able to absorb timing differences between the transmit and receive clocks. Data is written into the FIFO in the transmit clock domain and read in the receive clock domain. The design and operation of this FIFO must account for the dynamic variations in phase between the transmit clock domain (Tx Clock Out) and the receive clock domain (Rx Clock). The FIFO depth must be large enough to store all transmitted data until it has been safely read into the receive clock domain. The separation from the write pointer to which the FIFO data is written and the read pointer from which the FIFO location is read (write-to-read separation) must be large enough to ensure the FIFO location can be read into the receive clock domain. The deassertion of the incoming CTL/CAD signals across a rising CLK edge is used in the transmit clock domain within each receiver to initialize the write (load) pointer. The same deassertion CTL and CAD signals is read from the FIFO synchronous to the receive clock domain and used to initialize the read (unload) pointer. The separation between the write and read pointers is calculated based on worst-case variation between the transmit and receive clocks. Note also that CTL cannot be used to initialize the pointers for byte lanes other than 0 in a multi-byte link, because CTL only exists within the byte 0 transmit clock domain.

[ Team LiB ]